Turn the power back ON at the circuit breaker and confirm that the LED on the Wall Switch lights up purple. Install the Wall Switch into the gang box and install the faceplate.Ĩ. Ensure all wire nuts are securely fastened.ħ. Turn the power back OFF at the breaker and install the iDevices Wall Switch according to the diagram. Note these two wires for future reference.Ħ. ![]() The wire that is not energized is the “load” wire. Using your voltage detector, identify which of the two wires you removed is energized. ![]() It's not necessary to remove the ground wire.ĥ. Note: If you have more than two wires connected to your switch (not including the bare copper or green-coated ground wire), please see the 3- and 4-way installation instructions. Note: Your home’s wiring may differ please consult a qualified electrician.Ĥ. Remove both wires from the terminals of the existing switch and cap with the provided wire nuts. If there are no neutral wires present, you may need to run additional wires please consult a qualified electrician. Confirm the gang box contains a neutral wire (typically white). Take a photo of the existing wiring for future reference.ģ. Remove the existing faceplate and switch from the gang box. Turn OFF the power at the circuit breaker.Ģ. Select Transfer from iOS Device and select Next (linked iPad only) to see. Single pole switches are used to control one or more lights/fixtures from a single location.ġ. On your new device, install and open Signal, and complete registration, if prompted. If you are not comfortable working with electricity do not attempt to install the iDevices Wall Switch and seek professional assistance from a qualified electrician. ![]() A working knowledge of electrical installation is required to install this product. Electricity is dangerous and can cause personal injury and property damage if handled improperly.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |